#Gta san andreas hydra full version#
#Gta san andreas hydra update#

Check the blog post I made after this one.ДЄnjum: I'm sorry to hear that. Okimawsome: It has been uploaded to Mediafire. Search GTAGarage for 'handling editor' or something similar.

#Gta san andreas hydra update#

If it helps, on GTAGarage they have a tool which allows you to edit the handling cfg while in the game itself, so you don't have to keep quitting the game to see the results they update automatically while you're in the game. Try tweaking every value in the handling cfg file and see what happens. Vikocho: I'm not quite sure to be honest mate.

#Gta san andreas hydra full version#

Download the full version of Hiew from Pirate Bay and see if the read-only error reappears. _MoLtEnLaVa_ and Sunfaam: Are you sure your version of Hiew is not the trial version? The trial version doesn't allow you to save your changes as it will say the file is read-only. We will now modify this exe to remove this restriction! This means the Hydra is traveling at the highest speed possible, but it is being restricted by the game's exe. Note: At this point, there should only be a small change in speed in the Hydra, but this is good. If you have noticed a (slight) change in the Hydra, then, congratulations, you have successfully modified the Hydra's handling and can now proceed onto the next steps. Be sure you have no mods causing these crashes, too! Anything like a foreign character or misplaced indentation within the handling.cfg could cause the game to crash. Read over my instructions and repeat the steps over and over again, paying close attention to the screenshots provided. If the game continues to crash, make a copy of the 'Copy of handling.cfg' file and try make the replacements within this file, rename it to handling.cfg and then try it in-game. If the game crashes with these new handling.cfg lines double-check you replaced them correctly. At this point I advise you test these handling lines out in-game before we proceed to modifying the gta_sa.exe

Once you have completed these replacements, save the handling.cfg file using File > Save and then close the window ensuring your changes have been made. Highlight this entire line of code and replace it with the following, using Copy and Paste: Now hold CTRL and F on your keyboard once again and hit Find Next until you find the line which begins with ' $ HYDRA'. Now replace it with the line below, using Copy and Paste: